BioWaterfall Filter Installation Guide
For Ponds Up To 5000 Gallons
BioWaterfall Filter Operation:
The Bio Waterfall Filter includes 5 types of filtration, to successfully keep your pond and waterfall clean. For best results, the waterfall filter should run continuously, and should be slightly elevated from the pond. It's important that the filter rack be cleaned regularly, and that the filter is level.
How to Clean BioWaterfall:
Remove the filter rack from the Bio Waterfall Filter. Clean out any debris, using a steady stream of water. Be sure to remove any debris from the filter rack and filter mat.
How to Install Pond BioWaterfall:
- Remove all the filter media and rinse off to remove debris/dust. Place the filter media back into the BioWaterfall in the same order it was in.
- Choose an appropriate location for the BioWaterfall, it should be high enough to allow for proper drainage.
- Create a stable foundation to place the BioWaterfall on. Ensure that the BioWaterfall is level and will drain properly.
- Attach the bulkhead fitting with the barbed fitting to the BioWaterfall with a gasket on either side of the pre-cut hole.
- To connect a waterfall pump (purchase separately) use non-kink tubing and clamps (purchase separately) connect the tubing to the barb-head fitting and secure with a clamp.
- With the flat plastic lid that is provided you may wish to use landscape materials to blend it into the surrounding features.
